Erhardt+Leimer Participates in ITMA Asia with ELCUT BTA 80

In ITMA Asia, Erhardt + Leimer will put forward its 90-year experience with ELCUT BTA 80.

  20 May 2014 09:07 Tuesday
Erhardt+Leimer Participates in ITMA Asia with ELCUT BTA 80

In ITMA Asia, Erhardt+Leimer, which operates in many fields such as plastic, weaving, rubber and nonwovens industry, will put forward its 90-year experience with new generation of ELCUT BTA 80. The fact that 400 (pcs) ELCUT BTA 80, which was put into the service of textile producers in the middle of 2011 at ITMA Asia by the firm preferred by many manufacturers in the global arena, have been sold within a period of three years shows that it has met the expectations of textile manufacturers. It is expected that this figure will exceed 500 (pcs) in 2014 with the introduction of the new generation of ELCUT BTA 80.

ELCUT BTA 80, which has always been successful since its introduction into the market, has set new standards for edge trims in textile. Long blades, which can be used on both sides, can provide that the system position in a precise manner with two buttons. The crotch edges sensors of cutting system and automatic follow-up control make possible that high performance can be obtained with minimum effort.

It Was Developed With Customers

The new generation of ELCUT BTA 80 was modified by being redeveloped thanks to requests of clients. As a result, there are now better quality for the first cut and longer blade life. Even the most difficult cutting processes can be performed in new generation of ELCUT BTA 80 reducing cuttings arising from edge of cut, without depending on knitted fabric quality and production speed which are necessary for modern cut. While the cutting process is carried out within the framed chain with an easy cutting system owing to the round blades on ELCUT BTA 80, 12-15 mm cuttings is formed for each direction.

Two blades at the cut point and each blades of ELCUT BTA 80, which are based on the principle of shearing, have a diameter of 120 mm and a wide of 5 mm.  One of the most important features of ELCUT BTA 80, which has less abrasion in this way, allows continuing to use the other side of the blade which becomes blunt by reversing it and therefore, the production does not halt.


COMMENTS
Dear guest; without being a member Comments on "guests" are referred to as. Comments, you use a special name and picture, menu access a member of your reviews, comments, and to check the answers to their members to take advantage of many more features that register!
What is your comment about this story?
1000 - characters left.